Itty Bitty Wallet Hardware

Itty Bitty Wallet

Hardware & Supplies

Everything you need to make your Itty Bitty Wallet, all in one place. Quantities below are for one wallet. Optional supplies are clearly marked so you can choose your preferred exterior and lining options before shopping.

Shop the 4 1/2" Flip Lock Wallet Frame

Shop fabric, stabilizer, zipper supplies, and sewing tools separately. Itty Bitty Wallet Kits are also available for a limited time, while supplies last.

Before you choose fabric: Non-fraying fabric is required for the exterior, Ripstop for the lining, and Decovil Heavy for stabilization. Other lining materials are not recommended.

Fabric requirements are approximate and may vary depending on fabric width, directional prints, color blocking, and cutting layout.

01   Fabrics

Exterior Fabric

Approx. 8" × 7" (20.3 × 17.8 cm) of non-fraying fabric scraps such as faux leather or faux suede, or printed vinyl.

Lining Fabric

Approx. 1/2 roll of Ripstop, based on an 18" × 58" roll.

Ripstop is recommended for the lining because of its lightweight construction. Other lining materials are not recommended.

Choose one, two, or three exterior fabrics depending on your preferred design option. This wallet is a great scrap-busting project!

02   Stabilizer & RFID

  • Decovil Heavy:
    One 7 3/4" × 4 3/8" (19.7 × 11.1 cm) piece of Decovil Heavy.
  • RFID Blocking Fabric (Optional):
    One 7 3/4" × 4 1/2" (19.7 × 11.4 cm) piece of RFID Blocking Fabric.

03   Hardware

04   Zipper & Pull (Optional)

Required only when making Lining Option 2 with the zippered coin pocket.

Follow the Itty Bitty Wallet sewing pattern instructions for cutting, stabilization, and assembly.